This document shows the update for the Pocket POD using Line 6 Monkey.  Be sure that Monkey is installed on your system using the following documents to ensure proper connection:

Connect your PocketPod Via USB to your computer, then run the Line 6 Monkey application.  If your software is out of date (or you want to reflash for trouble shooting purposes), you will want to update using the following directions.

1)  Select the "flash memory" to highlight (in blue), then select "update selection".

2) If Monkey asks you to register your gear, you can select “remind me later”.

3) Select "I Accept" for the software agreement and select “continue”.

4)  Follow the directions, then select "OK"

5) Select "yes" to continue

6) wait for the flash memory to update and be installed.

7) Turn your Pocket POD Off, then on, then select "OK"

8) When your unit has been sucessfully updated Line 6 Monkey will look like this:

Q: My update stopped in the middle of the process?

A:  During the Pocket POD update using the Line 6 Monkey software on a Windows Vista (32-bit and 64-bit) machine, the update may stop and will not continue.  This may occur on certain USB ports.  This issue can be verified if the progress bar stops partway through the update.  Note: If the update does stop, the system will not respond to requests to shutdown the computer, even after force quitting monkey.  After disconnecting the Pocket POD, the system can be shutdown.  The Pocket POD remains in boot mode after this occurs.  Reconnecting to Monkey and re-installing the firmware update does recover the Pocket POD.  Please make sure to test the Pocket POD on every USB port on your computer while troubleshooting this issue.  Completely remove any USB hubs, even if not in use.