These forums are read only, please use our new forums here.

Main :: Stompbox Modelers / ToneCore



My LINE 6 Filter Modeler stopped working? No lights when you click on a button? Is there a fuse inside I can replace?
by alpha8 on 2009-04-25 08:58:47

My LINE 6 Filter Modeler stopped working? No lights when you click on a button? Is there a fuse inside I can replace?



Re: My LINE 6 Filter Modeler stopped working? No lights when you click on a button? Is there a fuse inside I can replace?
by joshguss on 2009-04-26 14:53:57

Same problem here.  Just registered for this forum so I could post the same question...

Is there anything I can do?



Re: My LINE 6 Filter Modeler stopped working? No lights when you click on a button? Is there a fuse inside I can replace?
by Line6Hugo on 2009-04-27 10:23:05

alpha8,

You can try to see if resetting the unit will resolve the problem:

1) Disconnect all cables except for a power supply cable (if using a power supply)

2) Press and hold the 'A' and 'D' buttons down AS you power on the FM4 by plugging in a 1/4" cable into the Left/Mono input.

If you continue to have problems after a reset, you will need to take the pedal to an authorized service center:

http://www.line6.com/support/serviceCenters/

Regards,

Line6Hugo




The information above may not be current, and you should direct questions to the current forum or review the manual.