These forums are read only, please use our new forums here.

Main :: POD HD

Support forums for all POD HD products

POD HD400 will not connect
by twippoh on 2011-04-22 19:32:29.5930

I have updated the drivers and the firmware and the edit software will not connect

Mac OSX 10.5.8

RE: POD HD400 will not connect
by Line6Hugo on 2011-04-25 16:54:39.5900


First, can you provide us info on your Mac computer? (What kind of Mac? Also, go into 'About this Mac' from the Apple menu at the top left and select 'More Info.' Provide the Model Identifier, Processor name and speed, and the amount of memory.)

After gathering this info to send to us, please use the Line 6 driver uninstaller in the Applications/Line6/Drivers folder to remove the installed drivers. Then, go to the Line 6 website and download the 5.1.2 (previous version) drivers to see if the POD HD400 connects to the computer with that version.



Re: RE: POD HD400 will not connect
by twippoh on 2011-04-26 18:39:02.5550

Here you go,

Macbook pro


2.4 Ghz Intel Core Duo

4 GB 667 Mhz DDR2 SDRAM

The driver 5.1.2 did the Job


Re: POD HD400 will not connect
by akshayahlawat on 2012-10-22 04:13:42.7730

I have a similar problem, but you could say it is a little more extreme than this. My pod HD400 connects for a few seconds, it works fine, and then it disconnects and my macbook becomes really slow. On a couple of occassions my macbook crashed and rebooted. Also, when I try to select the pod hd400 as the output device, it disconnects that very instant.

I have a 2012 Macbook Pro:

2.9 Ghz Intel Core i7

8 GB 1600 Mhz DDR3 RAM

Intel HD Graphics 4000 512MB

OS X 10.8.2

Re: POD HD400 will not connect
by toneman2121 on 2012-10-22 05:48:38.6500

follow hugo's suggestion

The information above may not be current, and you should direct questions to the current forum or review the manual.